SoundMax SM-CDM1055 User Manual

Page 13

Radio operations

Press repeatedly BAND button to select your desired radio band in radio mode: FM1, FM2, FM3, FM (OIRT),

AM1 (MW1), AM2 (MW2). Each band can store 6 preset stations, for a total of 36 preset memory stations.

Tuning

Press PREVIOUS or NEXT button to manually adjust the radio frequency. Press and hold PREVIOUS/NEXT

buttons, the radio will seek to the next up or down strong and clear frequency station automatically. Repeat

this action to seek for other desired stations. To stop automatic search, press NEXT or PREVIOUS button.

Automatic seek/preset scan

Preset scan: Press A/PS button once to automatically search for saved stations in each band.

Automatic store: Press and hold A/PS button, the receiver will automatically scan and save stations for

the current band. As soon as automatic store is performed, the unit will start preset scanning.

Radio scan

Press SCN button. The unit will scan all saved stations in each band holding 5 seconds on each station.

Programming stations

There are 6 numbered preset buttons, under which you can store and recall stations for each band. Select the

needed station, then press and hold a preset button. The station will be saved in the memory under the

corresponding number. To recall a stored station, press the corresponding preset button.

Local/distant reception

Press and hold SELECT button, then press it repeatedly to select DX (LOCAL). If LOCAL is displayed, it means

that local station reception is activated. DX means that distant stations with both strong and weak signal are

received. Switch between LOCAL and DX by rotating VOL knob.

Mono/stereo reception (for FM radio)

Press and hold SELECT button, then press it repeatedly to select STEREO reception or MONO reception for FM

bands. Mono receptions enables achieve a better signal quality due to noise reduction. Switch between MONO