American Weigh Scales (AWS) LB-1000 - Manual (Page 5)

remove any items from the weighing platform and
press the TARE/PRINT key again to re-zero the
scale.
VII. Counting Feature
1. To enter parts counting mode, press CAL/MODE to
scroll through the weighing modes until “C” appears
on the bottom left of the display. The minimum
sample quantity is 5 and will be displayed as “S=5”
2. Continue to press the CAL/MODE key to select the
desired parts sample quantity: 5, 10, 20, 50 pieces.
After “50” is displayed the scale will cycle back to
g (grams).
3. With the sample quantity value still displayed on
the LCD, place the sample quantity on the platform.
Allow the sample to stabilize for 3~5 seconds then
press TARE/PRINT. The sample quantity is now set.
4. You can now add any number of the item on the
scale and a count will be displayed.
VIII. Memory Function
1. With the balance on, press the TARE/PRINT key to
ensure the balance is zeroed.
2. Place an item on the scale and press ON/MEM
when the display is stable. This action adds the
displayed weight into the memory buffer which is
normally set to zero. The display will show “0.0”
again.
3. Repeat step 2 above as many times as you need,
until you are ready to see the cummulative result.
4. To view the cummulative weight, press ON/MEM.
The total is displayed and memory cleared.