Alto Professional M5A - Manual (Page 7)

4. PANEL CONTROLS
SPO
TLIGHT
(1) Power Indicator
This blue LED lights up when the M series active monitor are powered on.
(2) Power Switch
This switch is used to turn the M series active monitor on or off.
Caution: Make sure your supply voltage is identical with the value marking
on your monitors before turning the power switch on.
(4) NEAR or FAR Field Selector
Via this switch, you can use your M series monitors in the near field or far
field configuration. Generally, near field option is designed for near distance,
and the speakers are placed relatively close to the listener, normally about
1~1.5m. As for far field option, it is usually designed for the larger sound
systems, where the monitor speakers are placed comparative farther away
from the listener.
(5) SENSITIVITY Control
Adjust this trim pot to get the proper input gain.
(3) AC Socket with Main Fuse
This socket is used to connect your M series active monitor speaker with
the mains. Fuse replacement should be done by qualified personnel only,
and only with same value fuse.
(1)
-. Features of the Active Models
(6) SIGNAL INPUT
This COMBO connector is used to input the program sources either in balanced
or unbalanced configuration. You can use either 1/4 jack or XLR connector.
(7) OUT/LINK
This balanced XLR connector is linked in parallel with the SIGNAL INPUT, and
it can be used to output the input signal directly to another active monitor.
(2)
(3)
(4)
(5)
(7)
(6)
5
Use only with a 250V fuse
SIG.INPUT
BAL/UNBAL
110-120VAC~4A 60Hz
+6
-30
dB
SENSITIVITY
POWER
SW
ON
OFF
FAR
NEAR
M5A
OUT/LINK
BALANCED
R LTO
SERIAL
MODEL
M
SERIES MONITOR
HIGH FREQUENCY AMP-60 WATT (FULL RANGE)
LOW FREQUENCY AMP-130 WATT (FULL RANGE)
PUSH
1
3
2 NEW
TIDE