Alto Professional PAM5A - Manual (Page 6)

5
2. PAM5A Active Live Monitor
2.1 Quick Start - Active Speaker Cabinet
Make all initial connections, with the power switches Off for all equipment and main volumes are closed.
Connect one side of the signal cable at your audio mixer in to Output Left - Right (with Stereo - Jack or XLR) and
the other side of the cable in to the Line Input (Combo) of your active speaker cabinet. Start always with the LINE
switch sensitivity in +6dB positions.
Caution: The Line Input (Combo) and Link (XLR) are connected in Balanced or Unbalanced mode (Positive 2 /
Negative 3 / Ground 1).
The input with RCA connector, work in direct mode and by-pass the Volume control.
(1)
(2)
(3) (4)
(5)
(6)
(7)
(8)
(10) (9)
PUSH
AC~220-240V
50Hz
FUSE 2A
ON POWER
OFF
PAM5A
VOLUNE
MIC
SENSITIVITY
LINE MIC
LINE
45dB 6dB
CLIP -10dB INPUT
SERIAL
MODEL
R LTO
Max
LINK
INPUT
(1) Power Indicator
This LED lights up blue when the PAM5A active speakers are powered ON.
(2) Power Switch
This switch is used to turn the PAM5A active speakers ON or OFF.
Caution:
Make sure your supply voltage is same to the value printed on the rear panel, before turn on the
switch, (230V - 50Hz # 115V - 60Hz).
2.2 Control Elements for PAM5A Rear Panel