Alto Professional Live Drive App - Manual (Page 17)

17
Loop Through Crossover
Bypass (subwoofers only):
Toggles between Standard and Bypass Modes.
When the button is off, the subwoofer is in
Standard Mode (the default) where the XLR
outputs' signal is high-pass-filtered to be sent
to a full-range loudspeaker. When the button
illuminates green, the subwoofer is in Bypass
Mode where the XLR outputs' signal will be
unfiltered and full-range (the XLR outputs
effectively function as loop-through connectors
in this case).
Tap the Lock Back Panel button to
disable the hardware DSP button
on the rear panel of the loudspeaker
or subwoofer. When locked, only the app will
control this setting. Tap the button again to
unlock it and re-enable the rear panel DSP
button.