Alto Professional TS110A - Manual (Page 8)

SPECIFICATIONS
Output Power:
300 W Continuous RMS (235 W LF + 65 W HF)
600 W Peak (470 W LF + 130 W HF)
Active Crossover: 2.5 KHz
Max SPL @ 1m: 120 dB Continuous, 123 dB Peak
Frequency Range: 53 Hz – 20 kHz (@ -10 dB)
Frequency Response: 70 Hz – 19 kHz (+ 3 dB)
Max Input Level: +18 dBu (input impedance: 15 k Ω)
Transducer Low: 10" (254 mm) woofer, 2" (51 mm) voice coil
Transducer High: 1" (25mm) exit with 1" (25 mm) neodymium compression driver
Horn Coverage: 80/100° H x 60° V nominal
Connectors: Mic/Line Input: two 1/4" TRS or XLR
Link Output: one XLR
Cabinet: Trapezoidal, with floor monitor capability. Injection molded, polypropylene
enclosure, with perforated steel grille
External Control: Volume, power on/off with LED, clip limiter with LED, ground lift
Protection: Over-excursion, thermal, driver
Power supply: 100-120 V or 200-240 V, 50/60 Hz
Inrush current at initial switch-on: 4.36 A
Inrush current after power supply interruption: 3.73 A
Mounting: Integrated pole-socket (36 mm dia.), one handle, four M10-threaded
sockets (2 top, 2 bottom)
Dimensions (H x W x D): 20.2" x 13" x 11.7" (513 mm x 330 mm x 297 mm)
Weight (speaker only): 26.6 lbs (12.1 kg)
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2)
THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
www.altoprofessional.com
MANUAL VERSION 1.1