Alto Professional TS115W - Manual (Page 20)

SPECIFICATIONS
Output Power: 800 W Peak (670 W LF + 130 W HF)
400 W Continuous RMS (335 W LF + 65 W HF)
Crossover: 2.5 kHz
Max SPL @ 1m: 125 dB Peak, 122 dB Continuous
Frequency Response: 65 Hz – 19 kHz (+ 3 dB)
Frequency Range: 54 Hz – 20 kHz (@ -10 dB)
Low Frequency: 12" (305 mm) woofer, 2" (51 mm) voice coil
High Frequency: Neodymium compression driver, 1" (25 mm) exit, 1" (25 mm) voice coil
Horn Coverage: 80/100° H x 60° V, nominal (@ -6 dB)
Input Control: Line/Mic – ∞ to +50 dB
Max input level: +23 dBu
Impedance: 15 k Ω
External Control: Volume, power on/off with LED, clip limiter with LED, ground lift
Connectors: Input: Two 1/4" TRS or XLR
Link: One XLR
Wireless connectivity: Bluetooth (A2DP)
Wireless range: 60-80 feet (18-24 meters), typical
Protection features: Over-excursion, thermal, driver
Power supply: 100 VAC, 110-120 VAC, or 220-240 VAC; 50/60 Hz
Cabinet: Trapezoidal with floor monitor capability. Injection-molded polypropylene
with perforated steel grille
Mounting information: Integrated pole socket (36 mm diameter); 2 handles; 5 M10 threaded
sockets (2 top, 2 bottom, 1 pullback)
Dimensions (H x W x D): 25.5" x 15.1" x 14.4" (648 mm x 384 mm x 365 mm)
Weight (speaker only): 36.2 lbs. (16.4 kg)
FCC ID: Y4O-TS112W
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT
ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
SHIELDED CABLES MUST BE USED WITH THIS UNIT TO ENSURE COMPLIANCE WITH THE CLASS B FCC LIMITS.
Inrush current at initial switch-on: 4.76 A
Inrush current after power supply interruption: 4.64 A
www.altoprofessional.com/wireless
MANUAL VERSION 1.3
Bluetooth PIN #: 0000