Installation, Configuration, Operation – ABUS Technologies SPI Smart Programmable Isolator User Manual
Page 8

ABUS TECHNOLOGIES INC.
8
Smart
Isolator
6. INSTALLATION
First Input:
EXT2 (-), EXT6 (+24) to connect wire. At this time smart signal processor doesn’t
have the function of protecting of protecting outside short circuit.
Second Input: EXT4 (-), EXT8 (+24V) to connect wire. At this time smart signal processor doesn’t
have the function of protecting outside short circuit.
Mounting Way: Please use guide-way type mounting. At mounting make sure the card position is
stable and firm. In order to make instruments have good heat dissipation please
vertically installs and reserve draught room as possible as you can.
7. CONFIGURATION
Programming Instructions
1. Five-core Communication Interface: For communication connection through
private data wire Handheld Communicator Model-1001.
2. Indicating Light: Power: indicating light (continuously lighted) in power
condition indicating light (communicating, fast flickering) in communication
condition indicating light (trouble, slow flickering) in trouble condition.
ALM1: At satisfying alarm conditions, indicating light lights for long time
ALM2: At satisfying alarm conditions, indicating light lights for long time
Under trouble of input/ output signal, indicating light flickers.
8. OPERATION
For best results, you may use the shielded signal cable to avoid power spikes.
Check all the wires before operating the instrument. Series of instruments can be used
with instrument for isolation and distribution of signal regarding to your application may
be for recording, controlling through DCS, PLC, etc. They are widely used in all kinds