Dell 2400MP - Manual (Page 26)

26 Using Your Projector
S
ATURATION
—Adjust a video source from black and white to fully saturated color.
Press to decrease the amount of color in the image and to increase the
amount of color in the image.
S
HARPNESS
—Press to decrease the sharpness and to increase the
sharpness.
T
INT
—Press to increase the amount of green in the image and to
increase the amount of red in the image.
DISPLAY (in PC Mode)
V
IDEO
M
ODE
—Select a mode
to optimize the display on
how the projector is being
used: PC, MOVIE, sRGB
(provides more accurate
color representation),
GAME , and CUSTOM
(set your preferred
settings). If you adjust the
settings for White
Intensity or Degamma, the
projector automatically
switches to CUSTOM.
S
IGNAL
T
YPE
—Manually
select signal type RGB,
YCbCr, YPbPr.
Z
OOM
—Press to digitally magnify an image to 10 times on the projection screen
and press to reduce the zoomed image.
W
HITE
I
NTENSITY
—Setting 0 to maximize the color reproduction and 10 to
maximize the brightness.
D
EGAMMA
—Adjust among the 4 preset values to change the color performance of
the display.
H
ORIZONTAL
P
OSITION
—Press to adjust the horizontal position of the image to
the left and to adjust the horizontal position of the image to the right.
V
ERTICAL
P
OSITION
—Press to adjust the vertical position of the image down
and to adjust the vertical position of the image up.
F
REQUENCY
—Change the display data clock frequency to match the frequency of
your computer graphics card. If you see a vertical flickering bar, use Frequency
control to minimize the bars. This is a coarse adjustment.