Directed Electronics Tube Driver System TD275/2150 - Manual (Page 7)

5
Follow these simple instructions and refer to the diagram below to
make your speaker connections:
•
Using at least 16 gauge wire, run wire from the speakers to the
amplifier(s) using the same precautions that you followed for
running the power, ground, and remote wires
• Cut off excess wire
• Use wire strippers to strip 1/4 inch of insulation at the end of
the wires
• Attach the speaker wires to the amplifier’s
POWERLOCK connector and plug
it in
S p e a k e r C o n n e c t i o n s
Right Speaker negative
Right Speaker positive
Remote turn on
Left Speaker positive
Left Speaker negative
Speaker Power Lock Connector
Powerlock connector
BACK TO CONTENTS