Dremel 670 User Manual
Page 4
KICKBACK may occur. Investigate and take
corrective action to eliminate the cause of blade
binding. Wet lumber, green lumber or pressure-
treated lumber and most plastics require special
attention during cutting operation to prevent
KICKBACK. Avoid cutting nails. Inspect for and
remove all nails from lumber before cutting.
When restarting a saw in a workpiece, center
the saw blade in the kerf and check that saw
teeth are not engaged into the material. If saw
blade is binding, it may walk up or KICKBACK from
the workpiece as the tool is restarted.
Support panels to minimize the risk of blade
pinching and KICKBACK. Large panels tend to sag
under their own weight. Supports must be placed
under the panel on both sides, near the line of cut and
near the edge of the panel.
Do not use dull or damaged blade. Unsharpened
or improperly set blades produce narrow kerf
causing excessive friction, blade binding and
KICKBACK.
Use extra caution when making a “Pocket
Cut” into existing walls or other blind areas.
The protruding blade may cut objects that can
cause KICKBACK.
6
7
Symbols:
IMPORTANT: Some of the following symbols may
be used on your tool. Please study them and learn
their meaning. Proper interpretation of these
symbols will allow you to operate the tool better
and more safely.
Symbol
Name
Designation/Explanation
V
Volts
Voltage (potential)
A
Amperes
Current
Hz
Hertz
Frequency (cycles per second)
W
Watt
Power
kg
Kilograms
Weight
min
Minutes
Time
s
Seconds
Time
ø
Diameter
Size of drill bits, grinding wheels, etc.
no
No load speed
Rotational speed, at no load
.../min
Revolutions or
Revolutions, strokes, surface
reciprocation
speed, orbits, etc. per minute
per/min.
O
Off position
Zero speed, zero torque...
1, 2, 3, ... Selector settings
Speed, torque or position
I, II, III,
settings. Higher number means
greater speed
o
Infinitely variable
Speed is increasing
selector with off
from 0 setting
Arrow
Action in the direction of arrow
Alternating current Type or a characteristic of current
Direct current
Type or a characteristic of current
5716 Dremel 2.625x4.25 6/18/02 10:29 AM Page 6