MIPRO mr515a(2ce228) - Manual (Page 7)

11 12
BODYPACK TRANSMITTER BODYPACK TRANSMITTER
8. Detachable Belt Clip: Allows 360 degrees
rotating to suittransmitting angles. To
detach simply use a screwdriver at a 45
degree angle to unfasten. see diagram.
1. To adjust volume (5), GT/MT Switch (6), simplypush down both snap
locks on the sides ofbattery cover and flip it backwards to expose the
adjustment panel.
2. The LED indicator flashes briefly when power on indicating normal battery
status. If no flash occurs it has either nobattery, the battery is drained or
installed incorrectly. Change accordingly.
3. Adjust Gain Control to desired volume. (Gain Control is irrelevant when
switch to GT position).
4. Plug the microphone connector into the input jack (1) and tighten the
connector screw by clockwise direction as shown in (Fig. 3).
(Fig.2)
(Fig.3)
2. OPERATING INSTRUCTIONS
Lavalier
Headset
CapsuleConnector
Theridgeonthe
connectormustmatchthe
indentationonthesocket
wheninserting. ”
AUDIO
SHIELD
4
3
2
1
PIN
SHIELD
AUDIO
BIAS
3
4
PIN
1
2
AUDIO
SHIELD
1
4
3
2
PIN
SHIELD
AUDIO
3
2 1
PIN
4
3
2
1
SHIELD
AUDIO
1
3
4
2
PIN
1 3
4
2
1 3
4
2
1 3
4
2
1 3
4
2
1 3
4
2
1 3
4
2 OFF ON BATT.
LOW
3. AF 4-PIN INPUT CONNECTION METHODS
(1) 2-Wire Electret Condenser Microphone Capsule
(2) 3-Wire Electret Condenser Microphone Capsule
(3) Dynamic Microphone
(4) Electric Guitar
(5) Line-in (Impedance 8K ATT. 10dB) Ω
(Fig.4)