Wireless amplifier, Specifications – MIPRO ma705(2ce161) User Manual
Page 10

- 8 -
Operating Manual
5. SPECIFICATIONS :
Specifications
Item
1. Max. Power Output
2. T. H. D.
3. FrequencyResponse
4. Speaker
6. Wireless Microphone
7. Antenna
8. C D Player
9. Audio Input
5. Receiver Module
10. Power Supply
11. Charging Time
12. Dimension
13. Weight
14. Exterior Color
Please Note:
50 Watts (RMS) in t o a 8
Load
Ω
< 0.1 %
50Hz ~ 18 Khz
3 dB
±
Built-in 8 Inch Full-range Speaker.
400 285 225mm
×
×
8.8 Kg
Black
Four Hours (Automatic Charging Management)
Balanced/Unbalanced Mic In Jacks and Line In Jacks.
Optional
Integrated
Up to 2 optional UHF or VHF receiver modules may be fitted
to a MA-705. Please consult with your local supplier for
frequencies
Suitable to use with MIPRO's hand held transmitter, o r bodypack
transmitter fitting with lavaliere or headworn microphones
Not all models are available in all markets and specific
modelconfigurations may vary from market to market. Please
consult with your local supplier for detail of the various
models/configurations available in your market.
The suitability of wireless microphone frequencies may
vary from location to location. Please consult with your
supplier for advice about frequencies suitable i n y o u r area. No
responsibility i s taken by Mipro for interference caused to/by
any wireless microphone frequency transmission/reception
under any circumstance.
Caution:
type.
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent
WIRELESS AMPLIFIER
Built-in two 12 Volt 2.7 A R echargeable Batteries and
90V ~ 264V Switching Power Supply.