Delta 900585 - Manual (Page 5)

5
CLEANING
Remove the protective coating from the machined surfaces of the drill press and all loose items. This coating may be
removed with a soft cloth moistened with kerosene. DO NOT use acetone, gasoline, or lacquer thinner for this purpose.
ASSEMBLING THE DRILL PRESS
Fig. 4
Fig. 5
Fig. 6
1. Assemble the column (A) Fig. 4, to drill press base
(B) as shown, using the three M8 x 20mm hex head cap
screws (C).
2. Assemble the table (D) Fig. 5, to drill press column
(A) as shown.
3. Thread clamp handle (E) Fig. 6, into holes in rear of
table bracket as shown. Align table (D) to base (B) and
tighten clamp handle (E).
A
C B
C
A
D
D
B
E