Delphi XM SKYFI3 - Manual (Page 9)

Getting Started
Setting Up the System
You can set up your Delphi Premium Sound System by following
these steps:
1. Connect the supplied 18-volt DC power adaptor to the jack on the rear
of the Delphi Premium Sound System. Plug the other end into the wall
outlet. You may also use 8 “C” batteries (not included).
2. The XM Antenna is located under the top cover of the Delphi Premium
Sound System. If needed (i.e. unit is placed away from a south facing
window or you live in an area without XM terrestrial repeaters), lift the
handle on the top of the unit and remove the cover to access the antenna
and wire management area.
Remove the cover by pressing
down on the two tabs with your
thumbs and sliding the cover
away from the front of the Del-
phi Premium Sound System.
Be sure that the antenna is
connected to the antenna jack
located inside the antenna
compartment on the top of
the Delphi Premium Sound
System.
You can wind the two cable
hooks in the compartment,
leaving just enough cable