Section 5, Getting started – Delphi NAV300 User Manual
Page 13
Delphi NAV300 User’s Guide
- 12 -
Section 5
Getting Started
Warning: For your safety, program the Delphi NAV300 and enter your
information about your destination BEFORE you start your journey. Do not
operate the Delphi NAV300 while driving.
Powering Up
Power on
Press the Power button located on the
lower left side for at least one second.
Power off
Press the Power button located on the
lower left side for at least one second.
NOTE: The Delphi NAV300 will continue to charge if connected to a 12V power
jack even when powered down. By default, the unit will power on when
connected to a 12V power source. You can change this setting by turning “Auto
Booting” to OFF in the Configuration Settings (Section 14 of this manual).