Delphi NAV300 - Manual (Page 11)

Delphi NAV300 User’s Guide
- 10 -
Section 3 Installing Delphi NAV300 in Your Vehicle
Warning: To avoid personal injury, follow the safety guidelines and
installation instructions provided so that the Delphi NAV300 does not obstruct
the view of the driver, interfere with the operation of any airbags and safety
features in the vehicle, or become airborne in the case of an accident. Do not
attempt to install Delphi NAV300 while driving.
Before installing the Delphi NAV300, check whether your vehicle is fitted with a
heat-reflecting or heated windshield. If so, you will need to purchase an external
antenna from your retailer to allow your unit to pick up GPS signals.
NOTE: Alternative mounting options may be available for your vehicle make and
model. Contact your retailer or Delphi for more information.
NOTE: In the state of California and Minnesota, it is necessary to use the
dashboard mount, according to state law.
Follow these steps to mount the suction mount to the windshield:
1. Flip up the GPS Antenna.
2. Using the two tabs on the bottom of the cradle,
locate the Delphi NAV300 and rotate it
rearward. While pushing in the two release
buttons, continue rotation until the unit is firmly
seated in the cradle.
3. Release the two grey buttons. Reverse the
operation to remove the unit.
4. Position the suction cup firmly against the
windshield at the desired location
5. Flip the lever towards the suction cup. The
unit is now secure for operation.
Pull the lever away from the windshield/dashboard mount to remove the suction
cup. Pull the release tab to release the suction. If the suction cup does not
adhere, clean the mounting area of the windshield with a cloth dampened with
isopropyl alcohol. Let the area dry, then reapply the suction cup. Be sure to
mount the unit when the windshield is warm – it may be difficult when the
windshield is cold.