Lenco SCR-97 USB - Manual (Page 4)

GB 2
ADJUSTING THE SOUND
WHEN RECORDING
The VOLUME control may be adjusted with no effect on
the recorded signal.
FOR PRIVATE LISTENING
Plug in headphones (ø3.5 mm stereo mini-plug) to the
PHONES jack.
When headphones are plugged in, the speakers are
automatically disconnected.
TO ADJUST THE VOLUME
MIN. MAX.
VOLUME
TURN ON / OFF THE SYSTEM
POWER
Press the POWER button to turn the audio on.
To change the audio mode between CD, USB DISK , RADIO and TAPE , set the FUNCTION switch while the power is on.
The audio mode is displayed.
Turn off the unit by pressing the POWER button.
The current time is shown on the display.
The clock is displayed on LCD display at standby mode. on LCD display at standby mode.
1. Press the PROGRAM / CLOCK-ADJ. button,
2. Press the NEXT or BACK to select 12 hours or 24 hours display.
3. Press the PROGRAM / CLOCK-ADJ. button, the hour digit flash. the hour digit flash.
4. Press the NEXT or BACK to adjust hour digit.
5. Press the PROGRAM / CLOCK-ADJ. button, the minute digit flash.
6. Press the NEXT or BACK to adjust minute digit.
7. Press the PROGRAM / CLOCK-ADJ. button again,
the correct time is shown on display.
CLOCK ADJUSTMENT
CLOCK-ADJ.
LCD display
LISTENING TO THE RADIO
2 . Set to RADIO
FUNCTION
RADIO
1 . Turn on the unit by
pressing the POWER button.
POWER
CD display
3 . Select a MODE. MODE
FM ST. FM MONO
4 . Tune in to a station.
5 . Adjust the sound.
VOLUME
MIN. MAX.
TUNING
FOR BETTER RECEPTION
FM
NOTE :
1. FM stereo LED indicator lights if receive FM stereo broardcast and the MODE switch
set on "FM STEREO".
2. When too much noise is heard during FM STEREO reception, set MODE switch to FM mono.
AFTER LISTENING
Turn off the unit by pressing the POWER button.
Unit will be automatically off after 4.5 hours without further operation.