Lenco SCD-50BT - Manual (Page 3)

EN-2
POWER SUPPLIED BY THE AC/DC ADAPTER
Plug the AC/DC adapter to the unit and the main power.
POWER SUPPLIED BY BATTERIES
The unit can be operated by batteries. Follow the below steps to install the batteries:
1. Remove the battery compartment cover gently.
2. Install 8 x 'C' size batteries (UM-2 or equivalent) taking care that the correct polarities are
observed.
3. Replace the battery compartment cover.
NOTE:
 The AC/DC adapter must be removed for the battery operation.

To avoid damage which may result from leaking batteries, remove the batteries when
they become weak or when the unit is not to be used for long period of time.

In standby mode, the unit will still consume some power, so it is better to remove the
batteries if the unit is not used for some days.
NOTE: If not any audio signal inputs to the unit in about one hour, the unit will switch off
automatically (except at radio mode).
PLAY THE RADIO
1. Press the POWER button to turn the unit on.
2. Press the FUNCTION button several times to enter the FM mode.
3. Rotate the TUN+/- control knob briefly to fine tune the radio station. Rotate and hold the
TUN+/- control knob clockwise/counter-clockwise for a few seconds to auto search radio
station forward or backward respectively (When an available station will be found, the
unit will broadcast it immediately and the searching will be stopped).
4. The external FM TELESCOPIC ANTENNA is directional. When receiving FM broadcasts,
fully extend the FM TELESCOPIC ANTENNA and position for the best reception.
5. Rotate the VOLUME UP/DN control knob to adjust the volume level.
6. Press the POWER button to turn off the unit.
STORING YOUR FAVORITE RADIO STATION
1. During playback, press and hold the MODE/PROG/MEM button for storing the current
station to the unit’s memory, the memory cell number flashes on the screen.
2. Press the STOP/M+ or 10+/M- button repeatedly to select the corresponding memory cell
among P01-P10 for storing the station.
3. Confirm your selection by pressing the MODE/PROG/MEM button.
4. Repeat the above steps for storing other stations.
5. During radio playback, press the STOP/M+ or 10+/M- button repeatedly to recall the
stored stations.