Lenco SCD-11 User Manual
Page 10
GB 8
If at any time in the future you should need to dispose of this product please note that: Waste electrical products
should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive)
Where to place the item :
Today’s furniture is coated with a wide variety of lacquers and synthetic-coatings that are treated with an extensive range
of cleaning products. Therefore, the possibility that some of these substances contain components that react adversely to
the rubber feet of the item and soften them, cannot be completely excluded. The rubber feet of the appliance can cause
discoloring to furniture surfaces. If necessary, place the appliance on a non-slide surface.
��E�IFI�ATION�
��� �E�TION
Channels:
2 channels
S / N ratio:
60 dB
Wow & Flutter:
undetectable
Sampling frequency:
44.1 kHz 8 x over sampling
Quantization:
1 bit DA converter
Pick up light source:
Semi - conductor laser
Pick up wave length
790 nm
�A��IO �E�TION
Tuning ranges :
FM 87.5 - 108 MHz
AM 522 - 1620 kHz
Antennas :
AM Built - in ferrite bar
FM telescopic antenna
GENE�AL
Output power:
2 W + 2 W (RMS)
Power consumption:
15 W
Speaker:
3" 8 OHM
Phones jack:
3.5 MM
AUX IN jack
3.5 MM
Power source:
AC: 230V ~ 50Hz
DC: 12V 1.5 x 8 UM2 / LR14 / "C" SIZE
Clock back up Battery
1.5 x 3 AAA / LR03
Dimensions:
Main unit
438 (L) x 262 (D) x 143 (H) mm
Remote control :
35 (L) x 18 (D) x 190 (H) mm
Weight
2.7KGS
Due to continuing improvement, the features and the design are subject to change without notice.
For information and support, www.lenco.eu
SCD-11 NO IPOD LENCO ENGLISH rev10 10
4/12/2009 10:24:26