Lenco MES-230 - Manual (Page 8)

7
1.4.3 Once you forget your own password, use the supervisor's
password "8200" to unlock it.
NOTE: If wrong password was input in unlock status, the
system will lock.
1.5 RATING - Set the rating of this player. If you want to
change the rating of parental lock, please input the
password to unlock first.
Options: 1 KID SAFE / 2 G / 3 PG / 4 PG 13 / 5 PG-R /
6 R / 7 NC-17 / 8 ADULT
1.6 DEFAULT - Reset to factory settings.
Options: RESTORE
2. LANGUAGE SETUP
2.1 OSD LANGUAGE - It is used to select different On Screen
Display language for different user.
2.2 AUDIO LANG - select preferred audio language.
(DVD only, need disc software support)
2.3 SUBTITLE LANG- Select preferred subtitle language.
(DVD only, need disc software support)
2.4 MENU LANG - Select preferred disc menu language.
(DVD only, need disc software support)
3. VIDEO SETUP
3.1 BRIGHTNESS - to set the brightness for the display.
Options: 0/2/4/6/8/10/12
3.2 CONTRAST - to set the contrast effect for display.
Options: 0/2/4/6/8/10/12
3.3 HUE - to set the colour impression for display.
Options: -6/-4/-2/0/+2/+4/+6
3.4 SATURATION - to set the saturation level for display.
Options: 0/2/4/6/8/10/12
4. SPEAKER SETUP
4.1 DOWNMIX
Options: LT/RT - Left/Right mix mode
STEREO - Select this option if you don't have a 5.1
channels amplifier.
ADJUSTING THE SLAVE SCREEN
UP/VOL+
During play back, press to increase volume directly.
DOWN/VOL- KEY
During play back, press to decrease volume directly.
MODE KEY
During playback, press repeatedly to adjust brightness, color,
contrast, sharpness, tint effect for the display and volume for
the audio output of the slave screen via UP/DOWN button near
the MODE button.
REVERSE KEY
During playback, press to reversing the screen.
16:9/4:3 KEY
Repeatedly press to choose the aspect ratio.
Disc Handling precautions
y Hold the disc by the edge so the surface
will not be soiled with finger prints.
Finger prints, dirt and scratches can
cause skipping and distortion.
y Do not write on the label side with a
ball-point pen or other writing utensils.
y Do not apply benzine, thinner, and liquid
that prevents against static electricity.
y Be careful not to drop or bend the disc.
y Instal only one disc on the disc tray.
y Do not try to close the disc tray when the
disc is not in stalled properly.
y Be sure to store the disc in it's case
when not in use.