Lenco MES-230 - Manual (Page 5)

4
Remote control unit
1. MUTE button
2. VOLUME+ button
3. VOLUME- button
4. REPEAT 1/ALL&A-B
button
5. MENU button
6. SUBTITLE button
7. PLAY button
8. TITLE button
9. AUDIO button
10. PAUSE/STEP button
11. F.BWD button
12. F.FWD button
13. ANGLE button
14. ZOOM button
15. DISPLAY button
16. SETUP button
17. TFT SET button
18. NUMERIC buttons
19. CLEAR button
20. STOP&DVD/SD/USB
button
21. ENTER button
22. NAVIGATION buttons
23. SLOW button
24. NEXT button
25. PREVIOUS button
26. SEARCH button
27. PROGRAM button
Connecting to an affiliated screen
This unit is equipped with another affiliated screen, you can use
the affiliated screen and player to appreciate the programme at
the same time, the connecting method is illustrated as below
using the in car adapter.
CHARGE THE BUILT-IN BATTERY
The player is with a rechargeable lithium battery. Before using
the battery, please make sure it is charged. If not, charge it first.
Slide the power switch to OFF position and then connect one
end of the supplied adapter to the wall outlet and the other end
to the unit for charging the built-in battery.
Note:
1. The battery only could be charged at powering off mode.
2. If the unit is not in use for a prolonged period of time, it is
recommendable to charge the built-in battery each three
months.
CONNECTING TO A CAR ADAPTOR
The car power adaptor is designed for use with vehicles that
have a 12V, negative ground electrical system.
WARNING:
Disconnect the car power adaptor when not in use. Not in use
in 24V vehicles.
CAUTIONS:
y Use the unit only with the recommended car power adaptor,
use with other car power adaptor might damage the unit.
y The recommended car power adaptor is for use with this
unit only. Do not use it with other equipment.
y In the interests of road traffic safety, do not operate the unit
or view video software while driving a vehicle.
y Make sure the unit is fastened securely to prevent from
moving outside of the vehicle in an accident
y When the inside of the cigarette lighter socket is dirty with
ashes or dust, the plug section may become hot due to poor
contact. Be sure to clean the cigarette lighter socket before
use.
y After use, disconnect the car power adaptor from both the
unit and cigarette lighter socket.
FUSE REPLACEMENT
FUSE
POSITIVE(+) CAP
NOTE: Don't throw out the positive(+) cap when replace the
fuse.
To the cigarette
lighter socket
Slave screen connector
To the cigarette lighter socket