Lenco MC-148 DAB+ - Manual (Page 14)

13
DAB+ OPERATION
DRC (DYNAMIC RANGE CONTROL)
This causes the radio to reduce the dynamic range of the audio signal.
The purpose of this is to adapt the dynamic range of the audio signal to
listening in a noisy environment.
NOTE:
this is not available on some DAB+ stations.
1. Press the
STOP/MENU
button in DAB+ mode, and use either / on
the unit, / on the remote to find . Press the PLAY/PAUSE
button on the main unit or ENTER button on the remote.
2. Choose between
DRC off
, DRC high and DRC low using either /
on the unit, / on the remote control.
3. Press the
ENTER
or PLAY/PAUSE button to save the setting.
FACTORY RESET
Follow the below steps to restore to factory settings.
1. Press
the
STOP/MENU
button. Use / buttons on the unit or /on
remote control to find , press ENTER button.
2. When you see , press ENTER button.
3. Select using / buttons, then press ENTER to reset process.
NOTE:
Once the reset has been taken place, you will lose all the stored
presets both on DAB+&FM mode, and the internal DAB+ registry.
SELECT LANGUAGE
Follow the below steps to select the language of the system.
1. Press
the
STOP/MENU
button.
2. Use  / buttons on the remote control to find , press
ENTER
button.
3. When you see , press ENTER button.
4. Use
 / buttons to select one of the system languages, press ENTER
button to confirm selection.