Lenco L-83 - Manual (Page 8)

8
1.
Adaptor:
Use this adaptor when playing 45 RPM records.
2.
Platter:
Place a record here to play.
3.
33/45 RPM Switch:
Switch 33 or 45 rpm for playing a record at a correct speed.
4.
REC:
Press it to enter into record mode.
5.
SPLIT
For stopping the current recording, forming a record file manually and
then going on recording the next track.
6.
Pick-up Set
7.
Pick-up Arm Lift Stick:
To raise up and down the Pick-up Arm and cue at a proper place of a
vinyl.
8.
Pick-up Arm Lock:
Use this to lock the Pick-up Arm in place when not in use.
9.
Dust Cover:
Use this to protect the turntable from exposure to dust. The cover may
be opened or removed during use, but should remain closed when the
turntable is not in use.
10.
RCA Line Out Cable
Connect the RCA line out to a mixer or an amplifier in your sound
system.
11.
Power Cord
Connect this cord to an AC outlet of the proper voltage.
12.
Power Switch:
For turning the power on or off through this switch. Please press this
button to re-start your device when operation was interrupted.
13.
USB Port Input:
Plug in a USB Pen Drive for recording the music from a record.
*The design is only for USB Flash Drive. To prevent the power supply is
not sufficient and overheated of the circuit(IC), always get the external
power supply if using a hard drive.
14.
LED
•
USB Record Operation and LED Signal Indication
•
USB storage device is not plugged. -> LED light is off
•
USB storage device is plugged in -> LED flashes
•
When the system is ready to record. -> LED light is on
•
Press REC button to start recording. -> LED blinks slowly.
•
Press SPLIT button to create new file in the recording.