Lenco L-85 - Manual (Page 6)

6
Assembly
Drive belt:
The belt and turntable platter have been installed properly at factory, but
the belt may be loose during transportation. If so, the following procedures
will be taken for belt installation by yourself.
A. Remove the rubber mat from the turntable platter and the E ring from
the turntable shaft, then release the turntable platter from the shaft
B. Put the drive belt on the inner rim of the turntable platter and pull it
through the hole
C. Hold the belt with your fingers and place the belt onto the motor pulley
as shown in the drawing.
D. Clip the E ring on the shaft and place the rubber mat onto the turntable
platter.
Caution:
1. Make sure that the drive belt is not twisted or distorted.
2. Avoid oil. Oil splashes will make the belt slippery.
Auto Return Reset:
Always do the reset for Auto Return once you move this product. The
mechanism of Auto Return will rotate irregularly when moving and it will
cause the malfunction of Auto Return. The following steps will reset the
mechanism to normal.
1. Place a record on the platter and play it.
2. Manually lever the tone arm and place it to the blank part of the end of
the record.
3. The mechanism of Auto Return function will be adjusted properly and
the tone arm will automatically return to the arm rest.