Lenco IPT-223 - Manual (Page 5)

8 9
COMMON PROCEDURES FOR INITIAL SETTINGS
1. Press SETUP button to access the setup menu.
2. Use the navigation buttons to select the item you want to modify, setting page with further setting
items displayed shows on the TV screen. Again use navigation buttons to make changes. Press
ENTER button to confirm modifications.
3. Use navigation buttons to switch to another setting on the main setting page.
4. Press SETUP button to exit main setting page.
1. SYSTEM SETUP
1.1 TV SYSTEM - it is used to select the TV mode.
Please select this option as per your TV set.
1.2 SCREEN SAVER - when the player is not in use for several minutes, a running DVD logo will move
across the TV screen to protect the TV screen.
Options:
On: Screen saver is enabled
Off: Screen saver is disabled
1.3 VIDEO - It is used to select the video output type according to your TV set after plugging to SCART
output socket.
1.4 HD OUTPUT - It is used to select the resolution value properly according to your TV set after HDMI
cable connected.
1.5 TV TYPE - it is used to select the TV scan mode, please set as per your TV set.
Options: 4:3PS : Normal Pan & scan mode
4:3LB : normal Letter box mode
16:9 : 16:9 wide screen mode
1.6 PASSWORD - input password to unlock the system. The steps are as follows:
1.6.1 Enter SYSTEM SETUP, select the PASSWORD item by scrolling the down navigation button, and
then press the right navigation button to select the input box.
1.6.2 Input user's password "0000" to unlock it, in this case, select the input box again to change the
password by inputting another new four numeric numbers and then press ENTER button to
confirm. When the password is changed, you are needed to input the new one to unlock the
system.
1.6.3 Once you forget your own password, use the supervisor's password "8200" to unlock it.
NOTE: If wrong password was input in unlock status, the system will lock.
1.7 RATING - Set the rating of this player. If you want to change the rating of parental lock, please input
the password to unlock first.
Options: 1 KID SAFE / 2 G / 3 PG / 4 PG 13 / 5 PG-R / 6R / 7 NC-17 / 8 ADULT
1.8 DEFAULT - Reset to factory settings.
Options: RESTORE
2. LANGUAGE SETUP
2.1 OSD LANGUAGE - It is used to select different On Screen Display language for different user.
2.2 AUDIO LANG - select preferred audio language. (DVD only, need disc software support)
2.3 SUBTITLE LANG - Select preferred subtitle language. (DVD only, need disc software support)
2.4 MENU LANG - Select preferred disc menu language. (DVD only, need disc software support)
3. VIDEO SETUP
3.1 BRIGHTNESS - to set the brightness for the display.
Options: 0/2/4/6/8/10/12
3.2 CONTRAST - to set the contrast effect for display.
Options: 0/2/4/6/8/10/12
3.3 HUE - to set the colour impression for display.
Options: -6/-4/-2/0/+2/+4/+6
3.4 SATURATION - to set the saturation level for display.
Options: 0/2/4/6/8/10/12
4. SPEAKER SETUP
4.1 DOWNMIX
Options: LT/RT - Left/Right mix mode
STEREO - Select this option if you don't have a 5.1 channels amplifier.
DISC HANDLING PRECAUTIONS
 Hold the disc by the edge so the surface will not be soiled with finger prints. Finger prints,
dirt and scratches can cause skipping and distortion.
 Do not write on the label side with a ball-point pen or other writing utensils.
 Do not apply benzine, thinner, and liquid that prevents against static electricity.
 Be careful not to drop or bend the disc.
 Install only one disc on the disc tray.
 Do not try to close the disc tray when the disc is not installed properly.
 Be sure to store the disc in its case when not in use.
IMPORTANT SAFETY INSTRUCTIONS

The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids,
such as vases, shall be placed on the apparatus.
 When the mains plug or an appliance coupler is used as the disconnect device, the disconnect device
shall remain readily operable. To be completely disconnected the power input, the mains plug of the
apparatus or the appliance coupler shall be disconnected from the mains completely.
 No naked flame sources, such as lighted candles, should be placed on the apparatus.
 Minimum distances 2.0cm around the apparatus for sufficient ventilation. The ventilation should not
be impeded by covering the ventilation openings with items, such as newspapers, table-cloths,
curtains, etc.
 The use of apparatus is in tropical and/or moderate climates.
 Attention should be drawn to the environmental aspects of battery disposal.
 CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
 Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
 The marking plate is located at the back of the apparatus.