Lenco iPOD TOWER 1 User Manual

Page 6

SYSTEM CONNECTION

DVD Player

Before connecting acoustic equipment, pay attention to the picture below.
Each connection must be safe and firm. Disconnect power cable until you have
finished all the connections.

FM antenna

PREPARATION

1) Before the unit is turned on, please check if all the connections are right and safe.

Then connect the main power.

2) Press the

button on the back panel to turn on the main power.

3) Press the

button on the remote control (or front panel) to exit the standby

mode.

POWER ON/OFF
STANDBY

STATE INDICTION OF DISPLAY SCREEN
1. In radio status, show the received frequency and mono/stereo.
2. In Audio-input, IPOD status, show the signal input and main volume status.

FAST FORWARD AND FAST REWIND

PREVIOUS AND NEXT

In play status, press the

button to go to the previous audio file; press the

button to go to the next audio file.
Note: These buttons are unavailable in Audio Input mode.

BASIC OPERATION

MUTE BUTTON

STANDBY MODE
Press the

button on the remote control (or on front panel) to switch

ON/OFF the Standby mode.
Note: Make sure that the unit is connected to the power source.

STANDBY

SLEEP BUTTON

In play status, press the

button on the remote control continuously, you can get

the different sleep time for this unit: 10 min, 20 min, 30 min, 60 min, 90 min, 120 min.
For example, if you press the

button to select ``10 min``, the unit will enter

sleep mode in 10 minutes.

SLEEP

VOLUME SETTING

Press the

buttons to turn the volume up or down.

VOL.+/-

In play status, press the

button to fast rewind or fast forward. Press the

button again or

button to resume playing mode.

Note: These buttons are unavailable in Audio Input mode.

PLAY

If you press the

button while playing, sound signal will not be heard. Press the

button again or the

buttons to resume the previous volume level.

MUTE

VOL+/-