beautypg.com

Pull the battery loader out, Insert the receptacle into the remote control – Lenco DVP-931 User Manual

Page 8

background image

6

Preparation of the Remote Control

Place the remote control on an even surface and insert the supplied
button cell into the remote control as follows.

1.Push the button towards left

2.Pull the battery loader out

3.Insert the battery into the receptacle

Make sure the polarity matches the
marks inside the component.

4.Insert the receptacle into the remote
control.

2

CR2025

1

Cell data

Battery type: 1x CR2025 , 3 V
Service life: approximately 1 year (for normal use and room
temperature)

Using Of Remote Control

Point the remote control towards the main unit when operating.
The remote control works best at a distance less than 5 m and at an
angle of up to 30 to the front of the unit. No obstacles may stand in
the way between remote control and infrared sensor and do not
place the remote control in direct sunlight. If the remote control unit
fails to work even when it is operated near the player, replace the
battery.

Notes on batteries
If the remote control is not used for a long period of time, please remove
the battery from the compartment.
Do not heat batteries or dispose of them in fires.
Do not dismantle, deform or modify batteries.

About Built-in Rechargeable Battery

Precautions related to battery recharge

1. Once the battery is fully discharged, immediately recharge it (regardless of whether you plan
to use the battery or not) in order to maximize the battery life. When the power is low, the battery
icon will be shown on the upper left corner of the TFT for warning.

2. To charge the battery, please connect this player to AC mains via the AC adapter and the charge
indicator will turn on in red, and the indicator will turn into green when the battery is fully charged.
This will take about 2-2.5 hours if the player is in off mode or 4.5-6 hours if the player is in working
mode.

Using and maintaining your rechargeable batteries

1. Please make sure you always use only the AC adapter included with the player to recharge
your batteries.

2. Recharge efficiency will degrade when the environmental temperature drops below 50

o

F

(10

o

C) or exceed 95

o

F (35

o

C).

3. The lasting time of the fully charged battery when a headphone is connected to the player is
approximately 1.5 hours

This manual is related to the following products: