Lenco DR-05-BT - Manual (Page 5)

11
STANDBY TREBLE BASS
TUNER / ENTER/ BT PAIR
SOURCE INFO/MENU/
SCAN/ PRESET/
VOL
12 8
9 10
Treble
Bass
Volume knob
Display screen
Bluetooth indicator
No. Description
1
2
3
4
5
6
Adjust the volume to a comfortable level.
Display source frequency, and playback information.
Indicates the mode status.
Tuner knob/ Enter
Point the remote control to this sensor.
In FM mode, tune the frequency up or down by steps of 0.05MHz.
In menu status, press ENTER to confirm selection.
Press repeatedly to select the source you want: FM, USB,
BLUETOOTH(BT), AUX IN, DAB.
7
8
9
10
11
Next
Source
Previous
In BT mode, press Next button to skip to next track.
In FM mode, press repeatedly to cycle through the radio information.
Standby
Remote control sensor
Components
Menu/Information
In DAB or FM mode, long press to enter the setting menu.
Preset
In radio mode, use Preset button to store favorite stations.
Play/Pause
12
In BT mode, press to pause the playback, press again
to resume playing.
Scan In FM mode,press to scan the available stations.
Tap up or down to enter the treble setting interface and use
the volume knob within 3 seconds to adjust the treble level
to get a vivid sound effect.
In BT mode, press to skip to previous track.
If you want to disconnect the paired devices, press BT PAIR
button to disconnect and the unit enters the BT pairing status.
Then use the phone device to make connection
.
Tap up or down to enter the bass setting interface and use
the volume knob within 3 seconds to adjust the bass level
to get a vivid sound effect.
Front View
Description of parts
In DAB mode, rotate to skip to next or previous stations.
In DAB mode, press briefly to cycle through the station information.
/ BT Pair
4
When the buzzer alarm goes on, press ENTER to stop the alarm.
In standby mode, press to enter the time and alarm setting.
Tap this button up or down to turn the unit on, or to
the standby mode.
or rotate the Tuner knob to enter the nap mode,the alarm will go
on 5 minutes later.