beautypg.com

Mower deck leveling procedure – Dixon 5501 User Manual

Page 14

background image

MOWER DECK LEVELING PROCEDURE

LEVELING PRINCIPALS:

A.

There are a total of (4) threaded adjusters which will control the attitude or pitch of the

mower deck. The adjusters have lock nuts on the bottom which can be turned up or

down to raise or lower the front and rear of the mower deck. Deck should be level or

pitched slightly higher in rear.

LEVELING THE DECK:

A.

Place the mower on a smooth level surface, check tire pressures to insure the mower

has a correct stance. Inflate tires as required: Front - 19 - 21 Ibs maximum Rear- 10-

14 Ibs maximum

B.

Rotate or turn each outer blade tip to align with the edge of the deck or side to side.

C.

Measure from the surface up to the bottom of the blade tip on the discharge side of the

mower deck. Retain this measurement. Move to the opposite side, check that

measurement is the same. If adjustment is required, turn the nut on the bottom of the

front threaded adjuster up or down until both side to side measurements are equal.

Retain measurement.

D.

Rotate or turn both outer blades to align with the deck in front to rear manner. Move to

the left rear threaded adjuster, "left rear is designated from operator position on the

mower". Turn adjuster nut up or down until rear of mower deck is positioned level to

1/8th of an inch higher than the side to side measurement. At this time, the mower deck

will hang or be suspended on (3) points. Move the right rear adjuster and take out the

slack which will be present by turning adjuster lock nut up. Confirm the measurement

used on the left rear of the deck.

NOTEThis will place the mower deck in a base measurement position. Additional adjustment

may be required to achieve desired cut for the type of grass or conditions being mowed.

Page 11