Naim Audio CD555 - Manual (Page 13)

E11
CD Player Control and Operation
16 CD Player Control and Operation
The operation and control of all Naim CD players is based on a common user interface. This
section of the manual describes the user interface, drawing attention to differences between
players where they occur.
The CD player control buttons are duplicated on the remote control handset which may also
provide some extra functions. The handset also provides CD programming facilities. See
Sections 17 and 18 for more information.
16.1 Player Controls
door: Opens and closes the door (CD555 only) .
disp: Scrolls through the display options of track, time and
display off
(CD555 only) .
Note: The CDX2, CD5 XS and CD5si display options can be
scrolled by pressing the remote handset disp key.
prev: Steps through the disc backwards, either one track at
a time, or sequentially if the button is held.
next: Operates in the same way as the prev button, but
moving forwards instead of backwards.
pause: Pauses play. Pressing pause a second time will
resume play. The pause button indicator will flash
when pause is selected
(CD555 only) .
Note: The CDX2, CD5 XS and CD5si can be paused by pressing
the remote handset pause key.
Note: If a player is paused for more than 10 minutes it will
enter a “static pause” mode in which the transport deactivates
to reduce wear. The player can be left in static pause mode
indefinitely. The pause button indicator will illuminate fully
when the player is in static pause mode.
stop: Stops play and resets the player to its start condition.
Pressing and holding
stop will clear any programmed
play order, or, if no play order is programmed, return
the player display to its defaults.
play: Plays a disc from track one unless another track has
been selected. Pressing
play while a track is playing
will re-start the track.
16.2 Player Control Modes
CD players have an optional control mode. This provides an
alternative interface in which fast forward and fast reverse
(rather than step forwards and step backwards) can be
selected by pressing and holding the CD player
next and prev
buttons respectively. The alternative interface also provides a
pause function on CDX2, CD5 XS and CD5si players selected
by pressing and holding the
play button. To select the optional
mode press and hold next while the player switches on. To
select the standard control mode press and hold prev while the
player switches on.
16.3 Player Display and Indicators
The alphanumeric display indicates track and index numbers,
time in minutes and seconds, or system messages. If a play list
is programmed the time displayed reflects the duration of the
programme. Depending on the model in question, some or all
of the indicators described below will be found adjacent to the
display:
HDCD: Indicates that an HDCD encoded disc is playing.
Note: HDCD decoding is not implemented on the CD5si.
repeat: Indicates that repeat has been selected from the
remote handset.
prog: Indicates that a play list has been programmed.
Information on play list programming can be found in
Sections 21.2.
track: Indicates display of number of tracks or current
track.
pause: Indicates that the player is paused.
stop: Indicates that the player is stopped.
play: Indicates that the player is playing.
time: Indicates display of disc time or track time.
16.4 Output Socket Selection
A pair of RCA Phono output sockets are fitted on CD player
rear panels to provide an alternative to the preferred DIN
socket. Proceed as follows to select the RCA Phono sockets.
With the player stopped, press and hold the remote handset
disp function (handset in CD mode) or, if fitted, the player
disp button until the CD player prog indicator flashes. Further
operations of the disp function will now cycle through each
combination of the two socket types (DIN only, RCA Phono
only or both). The selected option is indicated on the CD player
display as shown below.
Socket Option Player Display
DIN
O
Phono
Both
O
Press and hold the disp function a second time to exit from
socket selection mode.
To avoid compromised sound quality, do not select both unless
their simultaneous use is unavoidable.