Naim Audio CD555 - Manual (Page 10)

E8
CD5 XS
10 CD5 XS Introduction and Installation
The CD5 XS CD Player can be operated either from its internal power supply only or, for
improved performance, with an additional external Naim Flatcap or Hi-Cap power supply.
Connection of the power supply is illustrated in Diagram 14.2. CD player control and
operation is described in Sections 16, 17 and 18.
The CD5 XS should be installed on a dedicated equipment stand intended for the purpose. Do
not stand the player directly on top of another item of Naim Audio equipment. Care should be
taken to ensure that the player is level.
The CD5 XS is fitted with both analogue and S/PDIF digital output options selectable using a
rear panel switch.
A transit screw on the underside of the CD5 XS case should be removed before use and must
be replaced if the unit is to be re-packed and shipped. This transit screw must not be used in
any other Naim product. Do not invert the player once the transit screw is removed.
The player (and external power supply if used) should be installed in its final location before
connecting cables or switching on. Ensure that power amplifiers are switched off and the
preamplifier volume is turned down before the player (or external power supply) is switched
on. The player power button is located on the rear panel. The Flatcap power supply power
button is located on its rear panel. The Hi-Cap power supply power button is located on its
front panel.
11 CD5 XS Connections
11.1 Rear Panel
ch1
-ve
nc
nc ch2
CD5 XS
DIN Output
Note: The power supply link plug should be fitted unless an
external upgrade power supply is in use.
Note: RCA phono and DIN output sockets should not be
connected simultaneously.
Note: The Remote input socket is intended to accept external
control signals for multi-room applications. Contact your dealer
or Naim Audio directly for further information.
Note: The optional RS232 interface can provide external control
of the player in custom installations. Contact your dealer or
Naim Audio directly for further information.
RCA
phono output
right
Mains
input and
fuse
Power
switch
Remote in
S/PDIF digital
out
Digital/analogue
output switch
Power supply link plug
and upgrade sockets
(link plug fitted)
DIN output
RCA phono
output left
RS232 interface