Ryobi TC401 - Manual (Page 9)

9 — English
ASSEMBLY
UNPACKING
This product requires assembly.

Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Items in this Assembly section are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance. In Mexico, please call
01-800-843-1111.
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result in
serious personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
ATTACHING WATER SUPPLY KIT
See Figure 4, page 15.
The water supply must come from a fresh water main. NEVER
turn the water supply on high. The water supply valve provides
a convenient on/off control lever for starting and stopping
the water flow onto the cutting wheel.

Unplug the saw.
 Attach the water supply kit to the saw as shown using
the screw provided. Tighten securely.
 With the faucet turned completely off, attach the faucet
adaptor to a garden hose or outdoor faucet.
 Once the cutting wheel is installed, the tile saw is ready
to be used.
NOTE: The tool is rated for a maximum water pressure of
60psi.
NOTE: For dry cutting, it is not necessary to install the water
supply kit.
WARNING:
A 4-3/8 in. (111 mm) wheel is the maximum wheel capac-
ity of the saw. Also, never use a wheel that is too thick to
allow outer cutting wheel washer to engage with the flat
on the spindle. Larger wheels will come in contact with
the wheel guards, while thicker wheels will prevent cutting
wheel screw from securing wheel on spindle. Either of
these situations could result in a serious accident.
WARNING:
Do not use cutting wheels rated less than the no load
speed of this tool. Failure to heed this warning could
result in personal injury. Do not use wheel with cracks,
gaps, or teeth.
WARNING:
Do not use toothed or segmented wheels. Use only
continuous rimmed diamond wheels suited for masonry
materials.