Ryobi P2200 - Manual (Page 17)

13 — English
TRoUblEshooTINg
CALL US FIRST
For any questions about operating or maintaining your product,
call the Ryobi
®
Help Line!
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.
pRoblEM possIblE CAUsE solUTIoN
Line will not advance when
using the auto-feed head Line is welded to itself.
Not enough line on spool.
Line is worn too short.
Line is tangled on spool.
Lubricate with silicone spray.
Install more line. Refer to line Replacement earlier
in this manual.
Pull line while pressing button.
Remove line from spool and rewind. Refer to line
Replacement earlier in this manual.
Grass wraps around boom
housing and string head Cutting tall grass at ground
level. Cut tall grass from the top down to prevent wrapping.
Motor fails to start when switch
trigger is depressed Battery is not secure.
Battery is not charged.
To secure the battery pack, make sure the latches
on each side of the battery pack snap into place.
Charge the battery pack according to the instructions
included with your model.