Ryobi P2200 - Manual (Page 15)

11 — English
opERATIoN
ADVANCINg ThE lINE MANUAlly
See Figure 13.

Remove the battery pack or disconnect from power sup-
ply.
 Push the black button located on the string head while
pulling on line to manually advance the line.
lINE CUT-oFF blADE
See Figure 14.
This trimmer is equipped with a line cut-off blade on the grass
deflector. For best cutting, advance line until it is trimmed to
length by the line cut-off blade. Advance line whenever you
hear the motor running faster than normal, or when trimming
efficiency diminishes. This will maintain best performance
and keep line long enough to advance properly.
This trimmer is currently set at the 10 in. cutting swath. To
adjust to a cutting swath of 12 in.:

Remove the battery pack or disconnect from power
supply.
 Loosen the blade screw then rotate the blade 180°.
 Tighten the blade screw.
EDgINg
See Figures 15 - 16.
Rotate the rear handle when using the edger guide for edging
sidewalks and walkways.

Remove the battery pack or disconnect from power supply.
 Pull up edging boom coupler and turn handle end coun-
terclockwise.
 Release edging boom coupler when handle has been
rotated 180° and locks into place.
Always hold the string trimmer away from the body keeping
clearance between the body and the string trimmer. Any
contact with the string trimmer cutting head while operating
can result in serious personal injury.