Ryobi P530 - Manual (Page 9)

9
ATTACHING CIRCLE CUTTER
See Figure 4.

Remove Battery Pack From speed saw.
 Assemble circle cutter if necessary. Refer to “Assembling
Circle Cutter.”
 Remove bit if necessary. Refer to “Inserting/Removing
Bits” in this manual.
 Place adaptor under depth adjustment ring.
NOTE: Make sure the adaptor fits snugly.

Place circle cutter arm on top of depth adjustment ring.
 Screw threaded ring onto adaptor, securing circle cutter
arm.
 Insert bit. Refer to “Inserting/Removing Bits” in this
manual.
Fig. 4 ADAPTOR
DEPTH
ADJUSTMENT
RING
CIRCLE
CUTTER
ARM
THREADED
RING
ASSEMBLY
OPERATION
WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating tools. Failure to do so could re-
sult in objects being thrown into your eyes, resulting in
possible serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this tool. The use of at-
tachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this tool for the following purposes:
NOTE: Most of these applications require different types of
bits. Be sure to use the right bit for your tool.

Cutting electrical outlet openings in drywall or wood pan-
eling. It is recommended to use a 1/8 in. bit for cutting
wood paneling.
 Creating decorative wood accents
 Cutting tile
This product will accept Ryobi One+ 18 V lithium-ion
battery packs and Ryobi One+ 18 V nickel-cadmium battery
packs.
For complete charging instructions, refer to the Operator’s
Manual for the battery packs and chargers listed in the
General Safety Rules.