Ryobi P530 - Manual (Page 11)

11
USING CIRCLE CUTTER
See Figure 8.

Assemble circle cutter if necessary. Refer to “Assembling
Circle Cutter” in this manual.
 Attach circle cutter to speed saw if necessary. Refer to
“Attaching Circle Cutter” in this manual.
 Adjust depth of cut if necessary. Refer to “Adjusting
Depth Of Cut” in this manual.
 Loosen pivot point knob.
 Move pivot point knob to desired diameter dimension.
 Tighten pivot point knob.
 Start speed saw.
 Cut a pilot hole in the center of the intended circle.
 Line up pivot point knob with the lead hole.
 Begin cut, applying moderate, steady pressure.
 Hold the speed saw firmly with one hand and the handle
with the other.
CAUTION:
Too much force causes heat build up, which can shorten
the life of the bit.
 Work in a clockwise direction, continuing back to the
starting position.
 Stop speed saw.
Fig. 8
OPERATION