Operation – Ryobi HP37 User Manual
Page 9
9 — English
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating products. Failure to do so could
result in objects being thrown into your eyes, resulting in
possible serious injury.
APPLICATIONS
You may use this product for the purposes listed below:
Driving screws with screwdriver bits
Light-duty drilling
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be locked when not
in use or carrying at your side.
TO CHARGE
See Figure 2.
This tool has been shipped in a low charge condition to
prevent possible problems. Therefore, you should charge it
overnight prior to use.
NOTE: Batteries will not reach full charge the first time they
are charged. Allow several cycles (driving screws followed
by recharging) for them to become fully charged.
NOTE: This power unit is intended to be correctly oriented
in a vertical or floor mount position.
If the charger does not charge the screwdriver under normal
circumstances, return
both the screwdriver and charger to
the nearest authorized service center for electrical check.
TO CHARGE SCREWDRIVER WITHOUT
USING CHARGING STAND
See Figure 2.
Insert charger plug into input jack making sure they are
properly connected.
Charger can be used with normal household voltage
of 120 volts, AC only, 60 Hz.
Connect charger to power supply.
After normal usage, a minimum of 10 hours of charging
time is required to fully charge screwdriver.
Do not place charger in an area of extreme heat or cold.
It will work best at normal room temperature.
OPERATION
1
22
19
16
CHARGER
PLUG
CHARGER
INPUT
JACK
Fig.
BACK SIDE Of CHARGING STAND
2-5/8 in.
SLOT
CHARGING
STAND
CHARGER
CHARGING
PLUG
Fig. 3
WALL
ANCHORS
PILOT
HOLES
SCREWS
CHARGING STAND
Fig. 4
BIT STORAGE
BIT(S)