Ryobi FPR3000 - Manual (Page 8)

8 — English
ASSEMBLy
wARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
wARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result
in fluids entering your eyes resulting in possible serious
injury.
wARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
CONNECTING / DISCONNECTING PAINT
TUBES
See Figure 2, page 12.
Paint travels from the paint can to the sprayer, pads, and/or
roller through the paint tubes.
To connect the paint tubes to the machine:
 With the machine unplugged, push the connector on the
end of the paint tube into the quick-connect main outlet
until it clicks. Pull on the tube to be certain it is properly
secured.
 If using both outlets, connect a second paint tube to the
quick-connect secondary outlet.
To disconnect the paint tube from the machine:
 Hold the tube in your hand and push the release
button. Remove tube to disconnect.
INSTALLING / REPLACING THE PAINT ROLLER
TO THE ROLLER HEAD
See Figure 3, page 12.
 Place roller caps in each end of a paint roller.
 Align pins in the end of each roller cap to the slot inside
the roller head. Snap into place.
INSTALLING THE PAINT ROLLER, CUT-IN OR
CORNER PADS TO THE PAINT TUBES
See Figure 4, page 12.
Connect the roller head to the handle before installing to
the paint tube.
To connect roller head to handle:
 Insert the collar on the roller head into the hole in the
handle until they “click” together.
 Place the connector on the end of the paint tube into the
quick-connect outlet on the handle. Push until it “clicks”
into place. Pull on the tube to be certain it is properly
secured.
To attach cut-in pad or corner pad:
 Insert the collar on the cut-in or corner pad into the hole
in the handle until they “click” together.
 Place the connector on the end of the paint tube into the
quick-connect outlet on the handle. Push until it clicks
into place. Pull on the tube to be certain it is properly
secured.
INSTALLING THE FINISH SPRAyER
See Figures 5 - 6, page 12.
NOTE: The blower hose is only used for painting with the
finish sprayer.
 Align the holes in the blower hose connector with the pins
on the machine hose connector.
 Push the blower hose connector towards the machine and
turn the connector clockwise to lock the hose in place.
 Connect the other end of the blower hose to the finish
sprayer following the above steps.
 Turn the dual control knob to the left and place the ma-
chine in the single user mode (paint tube connected to
quick-connect main outlet).
NOTE: When using the finish sprayer, you cannot use the
paint roller, cut-in pad, or corner pad.
 Once the paint tube is attached to the machine connect
it to the finish sprayer by placing the connector on the
end of the paint tube into the quick-connect outlet on the
finish sprayer. Push until it “clicks” into place. Pull on the
tube to be certain it is properly secured.
NOTE: The paint flow knob on the finish sprayer, makes
adjusting paint flow quick and easy. Simply turn the knob
counterclockwise or clockwise until the desired flow is
attained.