Toro CCR 3650 GTS Snowthrower 38517 - Manual (Page 8)

Product Overview
Figure 9
1. Discharge chute 6. Knob
2. Chute crank 7. Handle bolt (2)
3. Control bar 8. Rotor blades
4. Handle 9. Fuel tank cap
5. Control panel
Figure 10
1. Key switch 3. Recoil start
2. Primer 4. Choke lever
Operation
Note: Determine the left and right sides of the machine
from the normal operating position.
Gasoline is extremely flammable and explosive. A
fire or explosion from gasoline can burn you and
others.
• To prevent a static charge from igniting the
gasoline, place the container and/or snowthrower
on the ground before filling, not in a vehicle or
on an object.
• Fill the tank outdoors when the engine is cold.
Wipe up spills.
• Do not handle gasoline when smoking or around
an open flame or sparks.
• Store gasoline in an approved fuel container, out
of the reach of children.
Mixing the Gasoline and Oil
This snowthrower uses a 50:1 gasoline-to-oil mixture. Use
Toro 50:1 2-Cycle Oil (Fuel Stabilizer Added) or an
equivalent high-grade, NMMA TCW-certified two-cycle oil.
Important: To prevent engine damage, do not use
automotive oil (such as SAE 30 or 10W30) or fuel mixed
at the wrong gasoline-to-oil ratio.
1. Pour a half US gallon (1.9 liters) of fresh, unleaded
gasoline into an approved fuel container.
2. Add two-cycle oil to the gasoline according to the chart
below (Figure 11):
Figure 11
50:1 Gasoline-to-Oil Ratio Mixing Chart
Gasoline Oil
1 US gallon (3.8 liters) 2.6 ounces (80 ml)
2 US gallons (7.6 liters) 5.2 ounces (160 ml)
3. Install the cap on the fuel container.
8