Toro CCR 3650 GTS Snowthrower 38517 - Manual (Page 6)

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step Description Qty. Use
Handle bolt 1
Curved washer 1
1.
Knob 1
Install the handle.
Discharge chute 1
Phillips head screws 3
Washers 3
2.
Locknuts 3
Install the discharge chute.
Chute crank and mounting plate 1
Bolts 2
3.
Locknuts 2
Install the chute crank.
1. Installing the Handle
1. Cut the plastic tie that secures the control cable to the
handle.
Note: Hold the cable taut to ensure that it stays
connected at the bottom.
2. Position the upper handle as shown (Figure 3).
Figure 3
3. Loosely install the handle bolts, curved washers, and
knobs (Figure 4).
Figure 4
4. Hook the end of the control cable spring into the
bottom hole of the control bar (Figure 5).
Figure 5
5. Fully insert the handle bolts (Figure 6).
Important: Ensure that you do not pinch the
control cable (Figure 6).
Figure 6
6. Tighten the knobs until they are snug.
7. Adjust the control cable. Refer to Adjusting the Control
Cable.
6