Wisdom Audio Series SW-1 - Manual (Page 6)

6
Placement Considerations
PRECAUTION
For your protection, review “Important Safety Instructions” and
“Operating Voltage” before you install your SW-1.
Note that adequate clearance for the AC cord and connecting signal cables
must be left behind your SW-1. We suggest leaving at least six inches (15 cm) of
free space behind your SW-1 so all cables have sufficient room to bend without
crimping or undue strain.
If possible, the SW-1 should also be placed in such a way that the power switch
on the rear panel is easily accessible. This switch disconnects power from the
unit completely, resulting in effective disconnection of the SW-1 from the AC
mains. You might think of this as a “vacation switch,” should you wish to turn
off your system completely when you will be away from home for a prolonged
period of time. Just remember to turn it back on again when you return.
Ventilation Your Wisdom Audio SW-1 has relatively modest ventilation requirements,
thanks to its remarkably efficient design. Typically, it becomes only modestly
warm during normal operation. Still, please be certain to keep the vents on the
sides of the amplifier clear of any obstruction. (The rack mount attachments
have corresponding vents.)
Mechanical drawings are included in this manual to facilitate special installa-
tions where necessary (see “Dimensions” at the end of this manual).