Changing the pasta disc – Weston Roma Tube Pasta Machine User Manual

Page 8

-8-

-9-

CHANGING THE PASTA DISC

1. Turn the

Handle a half of a turn counter-clockwise to reverse the dough in the Auger a bit.

2. If the

Disc Rack and the Pasta Discs are stored inside the Pasta Machine Body,

remove the

Pasta Lid by gently pulling up from one side, popping the Pasta Lid off.

3. Twist the

Front Ring Nut counter-clockwise and remove. If the Front Ring Nut is too

tight, place the

Ring Nut Wrench over the Front Ring Nut and twist counter-clockwise

to loosen the

Front Ring Nut (figure K).

4. Remove the

Pasta Disc.

5. Place the

Pasta Disc of choice, metal side facing outwards, into the Front Ring

Nut. There are 4 tabs on the Pasta Disc the need to align with 4 notches on the Auger

Housing. NOTE: Each Pasta Disc is made of two pieces. Be sure the plastic portion

is lined up with the metal portion of the

Pasta Disc.

6. By turning the

Front Ring Nut in a clockwise direction, screw the Front Ring Nut

onto the

Auger Housing. Make sure the Front Ring Nut is snug, but do not overtighten.

NEVER use the

Ring Nut Wrench to tighten the Front Ring Nut, damage to the

machine may occur.

9. Open the

C-Clamp all the way open by turning the

handle of the

C-Clamp counter-clockwise. Attach the

Pasta Machine to a table or countertop by inserting

the end of the

C-Clamp into the opening on the side

of the

Pasta Machine Body (figure J.). Turn the

handle of the

C-Clamp clockwise to tighten the vice

onto the counter.

NOTE: Make sure the Handle of the Pasta Machine

is able to turn freely before tightening the

C-Clamp.

Make sure the

Pasta Machine is sturdy and tight onto

the countertop.

Figure J.

C-Clamp

Housing

Figure K.

Disc

Rack

Pasta

Disc

Front

Ring Nut

Wrench