Weston Jerky Slicer Attachment (Stainless Steel) - Manual (Page 6)

Figure 1 4. Position the Top Housing onto the Lower
Housing and line up the screw holes.
5. Secure the Top Housing to the Lower Housing
using the Housing Thumbscrews. DO NOT
OVERTIGHTEN!
6. Insert the Left Comb and Right Comb into the
Top Housing. Figure 1
NOTE: The Left Comb is marked with an “L” on the upper portion of the
Comb. The Top Housing is marked with an “L Comb” and “R Comb” to aid
in Comb installation.
ATTACHING TO THE GRINDER
BE SURE TO FOLLOW ALL SAFETY WARNINGS AND PRECAUTIONS
THAT ARE CONTAINED IN YOUR GRINDER INSTRUCTION MANUAL
BEFORE USING THE SLICER ATTACHMENT WITH THE ELECTRIC
GRINDER! NEVER LEAVE MACHINE UNATTENDED!
1. ALWAYS disconnect the grinder from the power source.
2. Unscrew the head locking knob (turn counter-clockwise) on the electric grinder
until the end of the threads are no longer protruding into the grinder output
housing.
3. Line up the grinder pin with the notch on the electric grinder adapter. Line up
the Shaft Adapter splines with the grinder output housing.
Figure 2
NOTE: For
#32 grinder users, you will have to place the #32 Adapter on the end of the Shaft
Adapter before installing to Grinder.
4. Be sure the Slicer Attachment is fully seated into the grinder. NOTE: You
may have to reposition the Slicer Shaft splines so that they match up with the
grinder output shaft. Make sure the grinder head locking knob
lines up with the groove in the side of the Electric Grinder Adapter.
5. Once the Slicer Attachment is properly positioned on to the electric grinder,
tighten the grinder head locking knob.
Figure 2
Shaft Adapter
Notch
Slicer
Attachment
Grinder
Head Locking Knob
of Grinder
Grinder Pin
Output Shaft
Splines
Shaft Adapter
Splines
Groove
ASSEMBLY INSTRUCTIONS
BE SURE TO FOLLOW ALL SAFETY
WARNINGS AND PRECAUTIONS THAT
ARE CONTAINED IN YOUR GRINDER
INSTRUCTION MANUAL BEFORE USING
THE SLICER ATTACHMENT WITH THE
ELECTRIC GRINDER! NEVER LEAVE THE
MACHINE UNATTENDED!
1. If not already attached, install the Shaft Adapter
onto the end of the Driving Blade Rack Shaft.
NOTE: To install the Shaft Adapter, loosen the
Shaft Adapter Set Screw using the supplied
Allen Wrench. Slide the Shaft Adapter onto
Drive Blade Rack Shaft and retighten Set Screw.
2. Install the Chute to the Top Housing using an Allen Wrench and Screws.
3. Insert the Blade Rack Assembly into the Lower Housing, guiding the Shafts
into the bearing journals. NOTE: When installing the Blade Rack Assembly,
you must position the drive shaft with the Shaft Adapter through the
hole in the electric grinder adapter before seating into the bearing journals.
WARNING!
Protective/cut-resistant
Kevlar Gloves are
recommended
whenever handling the
Blade assembly!
-7- -6-