WebDT SA1360 - Manual (Page 2)

SA1360
ENGLISH 2 3 ENGLISH
Precautions
Always exercise care when operating and handling. •
Never disassemble any portion of the enclosure. It will void any product warranty. •
Do not use any AC/DC adapter other than the one provided with the device or acquired from •
the manufacturer or its partners.
In the unlikely event that smoke, abnormal noise, or strange odor is present, immediately
•
power down the product and disconnect all power sources.
Please report the problem to your device provider immediately.
•
Pushing on the Power Button again will restart the appliance. •
Powering ON and OFF
The SA1360 is programmed to Power On automatically when power is first applied or re-
established. There is also a Power Button, located on the front of the SA1360. To turn the SA1360
on, push and release the Power Button on the front bezel. The power LED will be lit (blue), and
the corresponding interface will be shown on the display monitor.
To turn off the device, use the software shutdown interface provided, or unplug the appliance.
In the event of system lockup, unplug or re-plug the power cable. Also, the Power Button may
be used to perform a reset of the device. To do that, push and hold the Power Button for at least
4 seconds. The system will shut down and all unsaved work may be lost. Pushing on the Power
Button again will restart the device.
Server Installation
Please refer to the WCM6 Pro Installation Guide for software installation instructions.
Connect Player and Register to WCM Server
When you power on your signage player, the registration dialog will be launched automatically. •
You can also launch it from Start | All Programs | DT Research | WebDT Signage Player |
Register Player Again.
NOTE: If your signage player is located in a LAN with a WCM server, the player will
automatically register to the server in the same LAN.
Major Options
Wi-Fi 802.11a/b/g/n networking with dipole antenna •
The SA1360 Signage Appliance
Rear View Front View
B A C E F D H G
COM ports
USB 2.0 ports Audio jacks
Power button G
H
A
D B
E C DisplayPort++
DVI port Ethernet ports
DC-in
F
To exit the full screen introduction, press “Ctrl+Shift+Space” to exit the WebDT Signage Player. •
To re-launch the WebDT Signage Player, • navigate to Start | All Programs | DT Research |
WebDT Signage Player | Start player.
To register this signage appliance to
• another WebDT Content Manager Server, navigate to Start
| All Programs | DT Research | WebDT Signage Player | Register Player Again, and then the
Player Registration dialog will be launched. Fill in all fields to register. Click OK to register and
connect to the preferred WebDT Content Manager Publish Server.
Please refer to documentation included in the DVD of your package to start
• managing your
content, playlists and schedules via WebDT Content Manager.
Registration Information:
Player name: Leave default name or give a new name
Group name: If you did not create any group in WCM
server yet, leave it blank now
Organization name: my site (default)
Access Password: 123456 (default)
Publish Server URL:
http://(server IP address): (port number)/publish
or, http://localhost: (Port number)/publish