Dukane 8044 - Manual (Page 33)

33
1
Turn off the projector, and unplug the power cord. Allow the lamp
bulb to cool for at least 45 minutes.
6
Insert the new lamp, and tighten the 2
screws firmly to lock it in place.
Slide the lamp cover into place until it locks into position.
Slowly turn the projector so that the top is facing up.
3
After making sure that the projector
has cooled adequately, slowly flip
over the projector, so that the bottom
is facing up.
4
Hold the release button while sliding
and taking up the lamp cover.
2
Contact your local dealer to prepare a new lamp. Tell the dealer
your lamp type number. If the projector is mounted on the ceiling,
or if the lamp has broken, also ask the dealer to replace the lamp.
9
Turn on the projector, and reset the lamp timer. When the lamp has
been replaced after the message of “THE POWER WILL TURN OFF
AFTER 0hr.” is displayed, complete the following operation within
10 minutes of switching power on.
(1) While the projector running, press the MENU button to open the menu.
(2) Choose the “OPTION” on the menu using the
/ button, then press the button
or ENTER button.
(3) Choose the “LAMP TIME” using the / button, then press and hold the button
of projector or the RESET button of remote control for 3 seconds.
(4) Choose the “RESET” using the button.
In the case of replacement by yourself,
5
Unscrew the 2 screws, and slowly
pick up the lamp by the handles.
Replacing The Lamp
WARNING • Please carefully read the “User’s Manual - Safety Guide”.
CAUTION • Do not reset the lamp timer without replacing the lamp.
• When you replace the lamp, please replace also the air filter. The air filter may be
attached when you buy a replacement lamp for this projector. Please ask your dealer.
If the indicators or a message prompts you to replace the lamp, replace the lamp as soon
as possible. Using the lamp for long periods of time, or past the replacement date, could
cause it to burst. If the projector is mounted on the ceiling, or if the lamp has broken, do
not try to clean the projector or replace the lamp yourself.
Lamp cover
Release button
Handles
Screws
7
8
Lamp (continued)