Volant Ram - Manual (Page 3)

Closed Box Air Intake System
13-15 Dodge Ram 5.7L
PN 16457/164576
1/21/2015
INS16457 Volant Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: (909) 481.3888 · F: (440) 891-1868
3
E-Mail: [email protected] www.volant.com
Installation Instructions:
Locate your vehicle’s battery and disconnect the negative battery cable,
this resets the computer and clears old air flow data to prevent CEL errors.
1. Disconnect the ATS sensor harness from the sensor and remove it by twisting and pulling straight out. Save for
reinstallation. (Fig A)
2. Loosen the clamps holding the air duct to the throttle body and air box than remove the duct. Save in case
vehicle needs to be returned to stock. (Fig B)
3. Remove the breather hose from the air box by pulling straight out. (Fig C)
4. Remove the factory air box by pulling up and over the grommet posts. Save in case vehicle needs to be
returned to stock. (Fig D)
5. Remove the engine cover by pulling up and forward. Save for reinstallation. (Fig E)
6. Remove the factory breather hose from the driver's side vent and remove the Factory elbow from the factory
breather hose. Save for reinstallation. (Fig F)
7. Attach the ¾ in straight fitting into the factory elbow. (Fig G)
8. Re-install the factory elbow and attach the ¾ x 21in breather hose. (Fig H)
WARNING: Over tightening hardware may alter the integrity of the Volant air intake system.
9. Attach the 3.5 x 2.5 sleeve onto the throttle body with the #56 clamp. (Fig I)
10. Re-install the factory engine cover. (Fig J)
11. Attach the large L bracket to the headlamp side of the Volant box using the provided hardware. (Fig K)
12. Remove the two 13mm air box mounting tray bolts. Save for reinstallation. (Fig L)
13. Attach the long L bracket to the tray using the factory bolt. (Fig M)
14. Attach the small L bracket to the mounting tray using the factory bolt. Than attach the bracket to the box using
the provided hardware. (Fig N)
15. Attach the 4in hump hose to the Volant box using the #64 clamp. (Fig O)
16. Press the ATS sensor into the 1/2 Rubber grommet on the Volant duct. (Fig P)
CONTINUED ON NEXT PAGE