Vortech 1996-2004 Ford 4.6L Mustang GT - Manual (Page 4)

P/N: 8N020-030
© 2002 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
23JAN01 V2.1 (2V Maxflow Power Cooler.qxd)
iv
If the vehicle still has the battery located in the factory position, it must be relo-
cated into the trunk to make room for the water tank assembly. Vortech part
number 8N150-010 is a Heavy-Duty Battery Relocation Kit that may be pur-
chased separately. Commonly available “universal” relocation kits may be used
but they will most likely contain a smaller cable. Additional fabrication may also
be necessary when using a “universal” kit.
This product may not be legal for use on public roads in all 50 states.
NOTICES
(Read before installation is started)
Included in this kit is a smaller than originally supplied supercharger pulley. This new pul-
ley is recommended to achieve the best performance results. Removal of the factory
sealed pulley will reduce the supercharger warranty from three years to one year unless
the supercharger unit (with the original pulley still attached) and new pulley are sent into
Vortech for removal, installation and re-sealing. If the supercharger warranty is not a con-
cern or if the supercharger warranty has expired, the pulley may simply be removed and
replaced with the new part supplied. Hammering/prying etc. on the supercharger and/or
pulley will cause damage to the parts. Light heating of the supercharger pulley with a
propane torch (if the pulley is tight on the shaft) will aid removal. A return authorization
number is required before the supercharger and pulley are sent into Vortech. Call the
Vortech service department at (805) 247-0226 for a return authorization number. Return
freight (ground) will be paid by Vortech.
This product is protected by state common law, copyright and/or patent. All legal
rights therein are reserved. The design, layout, dimensions, geometry, and engi-
neering features shown in this product are the exclusive property of Vortech
Engineering, Inc. This product may not be copied or duplicated in whole or part,
abstractly or fundamentally, intentionally or fortuitously, nor shall any design,
dimension, or other information be incorporated into any product or apparatus
without prior written consent of Vortech Engineering, Inc.