Vortech 1996-2004 Ford 4.6L Mustang GT - Manual (Page 13)

5
P/N: 8N020-030
© 2002 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
23JAN00 V2.1 (2V Maxflow Power Cooler.qxd)
5. Water Tank Mounting (Plumbing Schematic)
A. Remove battery tray and notch to allow tank
to sit flush with bottom of tray and reinstall
(see Figure 5-a).
B. Place the water tank in the tray previously occu-
pied by the battery and secure using the original
battery hold down (see Figure 5-b).
C. Cut a piece of the 3/4” hose 50” in length and
attach to the 3/4” 90° fitting (located at the lower
rear of the water tank). Route downward and
toward the front of the car (see Figure 5-e on the
next page).
D. Cut a piece of the 3/4” hose 98” in length and
attach it to the water return fitting on the tank.
Route the hose downward and secure with the
supplied adel clamps and #12 hardware to the
bottom of the radiator core support (see Figure
5–c). Connect the hose to the outlet fitting on the
aftercooler routing it up and through the headlight
well (see Figure 5-d).
Figure 5-a
Figure 5-b
Figure 5-c
Figure 5-d