Vortech 1993-1997 5.7L LT1 F-Body - Manual (Page 7)

2. Water Pump Mounting
A. Connect the wiring harness to the water pump.
Following the photo (photo - 2) and using the
bracket as a guide, mark and drill holes in the
driver’s side outer frame rail and attach with
the supplied hardware.
B. Attach a 16GA eyelet to the negative wire
(brown) and route to a clean ground free from
paint and vehicle undercoating.
C. Connect the red wire to the positive wire (black
wire with yellow stripe) using the supplied
solderless connector. Route the red wire to
the power distribution box located on top of
the driver’s side inner fender well. Trim wire
length if necessary and connect to fuse #11
(underneath the fuse box cover) using the
supplied fuse tap, fuse and fuse holder (make
sure that the supplied secondary fuse is spliced
into the power wire).
Photo - 2
HOSE/COMPONENT SCHEMATIC
2
Water Pump
Long 90 ° x 3/4” Elbow (Trim Core End)
Water Out Water In
Aftercooler
Core
Discharge Air
(To Throttle body)
Air In
Water
Cooler
Tank
Long 90 ° x 3/4”
Elbow
(Short Leg to Tank)
1-1/4”
Filler Hose
Cap Adapter
Filler Cap
3/4” x 48”
3/4” x 34”
90 ° x 3/4” Elbow
1/2 NPT x 3/4”
Flow
Flow
3/4” x 90”
1/2 NPT x 3/4”
Pump
(-)
(+)
© 2000 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
31JAN00 V 1.0